Keenovo Silicone Heater 170mm x 170mm for Stealth Fork 180mm 3D Printer Build Plate HeatBed Upgrade

Keenovo Silicone Heater 170mm x 170mm for Stealth Fork 180mm 3D Printer Build Plate HeatBed UpgradeDescription: Wonderful Keenovo silicone heater for your Stealth Fork 180mm 3D Printer upgrade (aluminum build plate not included). 170mm x 170mm with pre made mounting holes. Built with 300W with strong and fast heating performances. Wire length: 1m, long enough to wire around with your own thermal fuse. Plant applied Lohmann adhesive backing for excellent performance at high temperatures(stands up to 270C) and easy mounting. Comes with a free NTC

Description:

• Wonderful Keenovo silicone heater for your Stealth Fork 180mm 3D Printer upgrade (aluminum build plate not included).
• 170mm x 170mm with pre-made mounting holes.
• Built with 300W with strong and fast heating performances. 
• Wire length: 1m, long enough to wire around with your own thermal fuse. 
• Plant applied Lohmann adhesive backing for excellent performance at high temperatures(stands up to 270C) and easy mounting.
• Comes with a free NTC 100K thermistor ( Beta 25/50 3950K-1%, Click Here for the R-T datasheet. Choose type 11 or 13 in Marlin or generic 3950 in Klipper firmware unless specified otherwise.)

Important Notes:

• Heaters may get super hot. Please handle with care.
• Before purchase, please kindly check if the hole pattern fits your build plate.
• Please note that the only known locations are the four mounting holes. For the additional holes, such as those used for Earth PE or a thermal fuse, different manufacturers may position them slightly differently, which could potentially interfere with the heater wires.
• Red wires are the Thermistor sensor extenstion wires, white wires are for voltage supply to the heating element.
• A supporting frame/layer is strongly suggested to have the heating element "sandwiched" tightly for better heating result. Please kindly check this post about a Perfect Installation.
• According to feedbacks from customers, the printer's stock SSR is not able to handle the heater. Please kindly consider replacing it and check this post for SSR Wiring.
• As we receive customer feedback, we do make small alterations to our products if we feel they improve the their performance and stability. The item(s) you receive might reflect some of these slight changes and improvements.