3D Carbon Passenger Side Dash Interior Overlay - 2020+ Supra

3D Carbon Passenger Side Dash Interior Overlay - 2020+ SupraSticker Fab has distributed over 20,000 vinyl products in the last few years! This new platform will be a great canvas for their accents and protection items. Add some texture of the passenger side dash area with these inlays. Supra logo is included separately. Apply the logo where you want it and then apply the overlay to the dash. MATERIAL DETAILS Dragon Wrap Carbon Fiber Film is a 5. 6 mil calendered vinyl film featuring a clear repositionable

Sticker Fab has distributed over 20,000 vinyl products in the last few years! This new platform will be a great canvas for their accents and protection items.

Add some texture of the passenger side dash area with these inlays. Supra logo is included separately. Apply the logo where you want it and then apply the overlay to the dash.

MATERIAL DETAILS

Dragon Wrap™ Carbon Fiber Film is a 5.6 mil calendered vinyl film featuring a clear repositionable permanent acrylic adhesive on an air-egress liner. This film has excellent dimensional stability, outstanding durability and outdoor performance. This repositionable permanent adhesive offers minimal initial bond growing to permanent bonds that facilitates application of large graphics. The air egress liner also aids in large graphic application.

Lasts up to 5 years outdoors.

Care Details: Concept Carbon Fiber film should be maintained to preserve long term appearance using standard aftercare products designed for textured exterior vinyl surfaces. A commercially available protectant such as Armor All or 303 Aerospace Protectant is recommended. DO NOT use waxes of any type.

INSTALLATION

First decide where to mount the Supra logo on the upper trim piece. It can be mounted closer to the center console or towards the passenger side door. This is completely optional and does not have to be used.

Align the top piece first. Start at the top left corner and work your way to to outside edge or vice versa. The material is pressure activated so when you get it exactly where you want it, this is when you can push down firmly.

See the photos above for a tip to install the bottom piece. Because of the angle, we recommend sticking it to the backing paper to help you insert it into the lower opening. You will apply it in the same manner as the top. Start at one side and work your way over to the opposite side. Press firmly once you are satisfied with the alignment.