Pay in installments of $33.74 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Aug 26 - Aug 31
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Lycon Skin Paraffin Wax HeaterDescription LYCOPRO Paraffin Professional Wax Heater is thermostatically controlled and suitable for LYCON Skin Thermoactive Paraffin Wax. Please read the manual and warranty card carefully before use. Features: 2. 75L (92. 9 fl. oz) capacity to max line Maximum temperature 70C (158F) Suitable for 220 240V, Australian Plug Thermostatically controlled Advanced heating technology Moulded from durable heat resistant materials Easy clean surfaces
Description
LYCOPRO Paraffin Professional Wax Heater is thermostatically controlled and suitable for LYCON Skin Thermoactive Paraffin Wax. Please read the manual and warranty card carefully before use.
Features:
- 2.75L (92.9 fl.oz) capacity to max line
- Maximum temperature 70°C (158°F)
- Suitable for 220-240V, Australian Plug
- Thermostatically controlled
- Advanced heating technology
- Moulded from durable heat resistant materials
- Easy clean surfaces
- Indicator light
- Protective clear lid
How To Use:
- Keep heater on flat surface.
- Remove the lid, put paraffin wax in heater, then close it with the lid.
- Keep lid on when heater is not in use.
- Connect the heater to a power point. Turn the switch to setting 10 to heat up the paraffin. Setting 10 is about 70°C (158°F), which is too hot to apply to the skin.
- Once paraffin has melted, turn the switch to setting 4.5 to 5 and allow the paraffin to cool down and maintain the working temperature for the paraffin, which is about 50°C. The setting will depend if the lid is on or off. Setting 5 is about 50°C (122°F).
- To increase temperature, move regulator dial clockwise.
- To reduce temperature, move regulator dial anti-clockwise.
- Always test the paraffin wax for a comfortable application temperature before use. How you test the paraffin temperature depends on how you are going to use the paraffin. If you are going to dip the hands or feet into the paraffin bath, you need to test the paraffin by dipping your own fingers or full hand into the melted paraffin. You can also paint some paraffin onto your own hand to check if it feels comfortable before you apply it on the client’s skin. If paraffin feels too hot, you must allow the paraffin to cool down some more, then test the temperature again as explained above, to make sure the paraffin is comfortable to use on the client’s skin.
NOTE: Please see Paraffin Application Tips for more hygienic paraffin use and application.
Warning:
- DO NOT immerse heater in water.
- DO NOT use heater near water.
- DO NOT allow water to splash onto heater.
- DO NOT clean heater with water.
- DO NOT overfill heater. Fill up to around 2cm from top of insert.
- DO NOT move heater when it has hot melted wax inside.
- Keep heater away from children.
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.5 ★★★★★
Based on 12 reviews
Sort
Product Reviews
★★★★★ 5
Dyna... who?
Size: 36 sqft
This stuff works great. Fraction of the cost to Dyna.. and just as good. Very sticky. Used in doors, floors and ceiling. Great product and performs flawlessly. I would highly recommend this.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 13, 2026
★★★★★ 4
Awesome, inexpensive alternative to name-brands!
Size: 36 sqft
Awesome. Stuck well with alcohol prep and time to let liquid flash-off. Very consistent, piece to piece. Backing peeled easily when desired. Compared to Amazon Basics, the butyl seemed a little thicker (infinitesimally) and stickier, foil was less thick than Amazon Basics. Very good value. Started with my nice car, but after completing project, sound dampened all cars in the immediate family it made such a noticeable difference in sound level and quality of music from soeakers. Recommended!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on October 21, 2025
★★★★★ 5
Easy to use
Size: 36 sqft, Size: 36 sqft
Very good and easy to use, made my 88 Chevy feel better
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 2, 2026
★★★★★ 5
Great sound deadening material with easy installation.
Size: 36 sqft, Size: 36 sqft
This sound-deadening mat was easy to install on the roof of my Toyota FJ Cruiser. It significantly stiffened the roof and dramatically reduced the wind noise inside the vehicle caused by my roof rack and lights. I can actually carry on a conversation again without shouting while driving on the freeway.
The 36-square-foot package was enough for my application, with about three sheets left over. The tiles adhered well to the metal without any special surface preparation. I only wish I had done this sooner.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 20, 2026
★★★★★ 5
Siless Hybrid 3-in-1 - Far Exceeded my Expectations!!!
Model: SLH20025
I recently installed the Siless Hybrid 3-in-1 sound deadening mat in my vehicle, and I’m genuinely impressed. For just $80 for 25 square feet, this product delivers performance that rivals materials costing twice as much — and with far less hassle. If you're on the fence......Just buy it! You will not be disappointed.
Easy to Install: Unlike traditional sound deadening products that are stiff, sharp, and temperature-sensitive, this mat is soft, flexible, and easy to work with. I cut it cleanly with regular scissors and pressed it into tight spaces using just my fingers, so if in you don't have a roller or install tool, a good pair of scissors and your hands can get the job done. With other brands like Dynamat, the aluminum layer often leaves micro cuts on your hands and tears up your fingertips, but Siless does not due the acoustic layer being on top and above the aluminum layer that holds the butyl layer. So, it's very easy on your hands.
Even in cooler temperatures (around 50°F), I had no trouble applying it but it goes on better heated. If warm outside, I would leave the entire box out in the sun for at least 30 minutes when it's warm or heats it's very pliable and easy to mold. Make sure its where you want it because once applied it's not ever falling off. and it became even more pliable and easy to mold. No heat gun, no mess — just straightforward application.
I installed 40–50 square feet throughout the interior, covering everything except the headliner and the flooring forward of the rear seat. The difference in cabin noise is astonishing. I can turn my radio up concert loud with gut-punching bass, and from outside the car, it sounds like a factory sound system at mid volume. I was blown away by how well it contains sound — both inside out and outside in.
My exhaust is pretty aggressive and now is barely audible from inside the cabin. While driving, it almost sounds like a stock factory setup. The Siless matting actually changed the driving experience and feels refined.
If you're skeptical about sound deadening gimmicks, I get it, but this is the first product I've used and when I needed more, I went Stright to the 3 in 1 Hybrid matting and purchased it again. I love researching before buying and that's very uncommon for me to do.
Note: Proper installation is key, and it does take time and patience. But if installed correctly and in the right places, it works better previously used from paint-on sound deadening to Dynamat.
Update Nov, 2025
After using it this in 4 separate vehicles now. I feel the Siless’s 3 in 1 Hybrid has nailed it for best budget deadener that is better than dynamat extreme in performance and installation
Protip: buy a roll of 2-3” aluminum tape and tape the seams. After trimming the edges tend to very sticky between the panels. I ran a strip of aluminum tape over the seems to create a better seal and true moisture
I used it on four vehicles now and have I have not been paid to review and purchased every order myself.
3 in 1 Hybrid deadener by Siless is the best all around easy to apply sound deadner period!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on September 29, 2025