Kiln Blanket Adhesive 750g

Kiln Blanket Adhesive 750gRecommended Use BLANKET ADHESIVE is a self setting or air drying adhesive of medium speed at normal ambient temperature. It was originally developed to bond layers of ceramic fibre blanket into modules or affix blanket to walls, etc. It has good air setting properties and once applied sets in about 10 40 minutes dependent on ambient conditions. Warmth will speed up the setting reaction but adhesive should not be applied to hot areas (above about 80C)

Recommended Use
BLANKET ADHESIVE is a self-setting or air drying adhesive of medium speed at normal ambient temperature. It was originally developed to bond layers of ceramic fibre blanket into modules or affix blanket to walls, etc. It has good air setting properties and once applied sets in about 10-40 minutes dependent on ambient conditions. Warmth will speed up the setting reaction but adhesive should not be applied to hot areas (above about 80°C) as it may gel rapidly and the adhesive properties will be adversely affected. 

Instructions For Use
BLANKET ADHESIVE is applied with a brush or knife to each joint face and the two parts of the joint are then pressed firmly together. To speed up setting time, make the joint in the usual way and then, reopen the joint allowing the opposing faces to become tacky before firmly pressing together again.

Maximum bond strength can be developed if necessary by stoving the joint at average temperatures of 180-220°C. This is not normally necessary for routine applications and simple air drying will provide a joint of adequate strength requirements.

Maximum operations service temperature 1350°C as an adhesive for fibre blanket. 

Storage
BLANKET ADHESIVE will keep indefinitely provided it is in a sealed container stored at normal room temperatures. If exposed to cold (below 15°C) BLANKET ADHESIVE will thicken appreciably; normal viscosity will restored if the material is warmed to 15°C for about 24 hours.

Advantages
BLANKET ADHESIVE is an inexpensive ready-to-use adhesive ideally suited to bonding ceramic fibre products. BLANKET ADHESIVE may also find application as an adhesive for other insulating refractory products such as Calcium Silicate or vacuum formed boards.