Steering Ram Clamps

Steering Ram ClampsGot a trail rig, Ultra4 car, trophy truck, or rock crawler? Keep that hydraulic cylinder in its place! These are the best on the market billet hydraulic steering cylinder clamps for mounting full hydraulic rams to your axle or chassis. Made to be a direct replacement for the standard PSC clamps. Designed to retain the steering cylinder ends to prevent catastrophic failure from the ram sliding side to side, plus it keeps the threaded end caps from

Got a trail rig, Ultra4 car, trophy truck, or rock crawler? Keep that hydraulic cylinder in its place!

These are the best on the market billet hydraulic steering cylinder clamps for mounting full hydraulic rams to your axle or chassis. Made to be a direct replacement for the standard PSC clamps. Designed to retain the steering cylinder ends to prevent catastrophic failure from the ram sliding side to side, plus it keeps the threaded end caps from backing out and blowing out the internals all over the trail. Keep your rig on the trail or in the race!

• Sized for 2.5" (SC2212, SC2213, & SC2218), 2.75" (SC2227), and 3.0" (SC2217, SC2228) hydraulic steering rams
  
• Clamps made from 6061 billet aluminum anodized clear
• Threaded weld block made from 1018 steel
• Grade 8, 1/2"-13 hardware
• Only 2 clamps required to mount steering ram (Middle PSC clamps recommended for racing)
• Sold in pairs

Optional hardware and weld block, as some may only want to replace the aluminum clamps on their PSC setup. Please verify your steering ram size before ordering. The sizes listed are based on internal bore size. External steering cylinder diameters for the 2.5", 2.75", and 3.0" rams are 2.875", 3.145", and 3.375" respectively.

***For off-road use only***

Torque hex drive bolts to 40 ft-lbs using blue thread locker.

Please e-mail us [email protected] if you have any special requests or a setup that is different than this. Also, take a look at our Low Profile Steering Cylinder Clamps.