Stillen 2016-2021 Infiniti Q50 [3.0t] Cat Back Exhaust w/ Carbon Fiber Tips - 504450

• Mild note at idle and Aggressive note under throttle
• Compliments the factory exhaust cut out nicely
• Delivers an aggressive look that matches the enhanced exhaust note
• Direct Bolt-On Installation
• Designed and Manufactured in-house at STILLEN HQ in Costa Mesa, CA and inspected multiple times to ensure the highest quality and fit

STILLEN has long been associated with Infiniti tuning parts for as long as Infiniti has been around, creating high performance products, and meticulously crafted exhaust systems that have proven time and again to produce the maximum horsepower possible. With the introduction of the 2016 Infiniti Q50 3.0L Twin Turbo V6, STILLEN immediately went into R&D utilizing their many years of experience with VQ engines, and the results were fantastic.

As with any turbocharged vehicle, we found quite a bit of power on the Infiniti Q50 3.0TT exhaust system. As with the intake system, the Luxury Car nature of the Q means that it was designed with Noise, Vibration and Harshness front-of-mind. That means that power-robbing compromises had to be made, the end result being that your Q50's 3.0TT can't breathe as well or make as much power as it should.

By streamlining the flow of exhaust gases and removing unnecessary restrictions in the system, after dozens of prototypes, STILLEN engineers unlocked a 26WHP* and 29WTQ Gain*. Those numbers are nothing to sneeze at, and you'd be hard pressed not to notice an additional 29lb/ft of torque*.

*Results May Vary

Customer Review

Take a listen to a Customer's Q50 with the STILLEN Cat-Back Exhaust System w/Carbon Fiber tips.

The STILLEN Q50 cat-back exhaust system has an aggressive tone under hard acceleration, but mellow during cruising, with that unmistakable STILLEN sound. The free flowing performance mufflers and tips are constructed of 304 Stainless Steel for long life, and includes a limited lifetime warranty. The piping is mandrel bent for smooth flow, and fuel mileage gains can be expected at cruising speeds.

Designed to fit beautifully into the OEM valance or as a compliment to a STILLEN Rear Diffuser, this system looks as good as it sounds. Available with three tip options to suit your tastes, choose from Carbon Fiber, Polished or Burnt-Titanium Look Tips to give your Q50's rear end that extra something it needed.

Y-Pipe

This 2.5" Y-Pipe configuration allows for better airflow. The Y-Pipe than connects to the 3" Mid-Pipe.

Mid-Pipe

The 3" Mid-Pipe than carries the exhaust gases to the rear of the vehicle where it branches back into 2.5" dual rear exit.

Dual Mufflers w/ Carbon Fiber Tips

Upon meeting the rear exhaust pipes the exhaust gases flow through the STILLEN engineered and manufactured mufflers. The 4.5" bolt-on exhaust tips enable you to adjust the tip position for a proper fit no matter what bumper or aero you choose to run at the back. Finally, the exhaust note is mild and well-mannered under normal driving conditions, but quickly turns aggressive and authoritative when under throttle.