Water Drops Top Coat 2*15ml set

Water Drops Top Coat 2*15ml setWater Drops Top A set of two components designed to create volumetric water drop effects on the surface of a nail coating. Set includes: Step 1 a glossy top coat with no sticky layer. Can also be used as a regular finishing top coat. Step 2 a liquid gel with no sticky layer that naturally gathers into droplets, creating a dew like effect. Directions for use 1. Base preparation Apply Step 1 over the finished design or base color and cure in the lamp

Water Drops Top

A set of two components designed to create volumetric “water drop” effects on the surface of a nail coating.

Set includes:

Step 1 — a glossy top coat with no sticky layer. Can also be used as a regular finishing top coat.

Step 2 — a liquid gel with no sticky layer that naturally gathers into droplets, creating a dew-like effect.

Directions for use

1. Base preparation

Apply Step 1 over the finished design or base color and cure in the lamp for 60 seconds.

After polymerization, do not touch the surface with your hands and do not wipe it.

2. Creating the “drops”

Apply a small amount of Step 2 and wait until the gel forms the desired droplet effect.

If needed, repeat the application to enhance or refine the result.

Cure in the lamp for 60 seconds.

ADDITIONAL INSTRUCTIONS

(Polymerization, application, and content filming conditions)

• Apply Step 1 in a thin layer (do not apply thickly).
• Polymerize Step 1 and Step 2 only in a 48W lamp.
• Cure without interruptions. Polymerization time — no more than 60 seconds.
• For white coatings, 30 seconds is enough to avoid yellowing.
• Lamps with lower power and small LED flashlights may cause yellowing of the coating.

When filming content

• Desk lamps with cool light 5600K and higher may start the polymerization process.
• During filming, do not position the lamp too close to the bottle or brush, as the brush may harden.
• We recommend filming this step quickly, without prolonged lighting exposure.

Volume: 2 × 15 ml

Manufacturer: TM “HEYLOVE”

Country: Ukraine

Ingredients:

Acrylates Copolymer, HEMA, Cellulose Acetate Butyrate, Pentaerythritol, Mercaptopropionic Acid, Dimethicone, BHT.

⚠️ Attention!

To avoid unwanted polymerization of the material during work, testing, or content filming, keep the open bottle or brush as far away from daylight as possible (especially from direct sunlight).

Please note that even on cloudy days, clouds allow a large amount of ultraviolet radiation to pass through, which can still cause the material to polymerize.