DAYTONA Anima 190cc FDX ENGINE

DAYTONA Anima 190cc FDX ENGINEThis 4 valve, 62mm bore x 62 mm stroke engine is the newest edition directly from Daytona Motor Co. The new FDX 190 comes stock with an updated 4 speed close ratio transmission, an AUTO DECOMPRESSION CAMSHAFT, and reinforced crankcases. The FDX motor is manufactured and assembled as a 190 at the Daytona factory. Daytona FDX 190 Engine Intake Manifold Wire Harness CDI: (4 selectable timing settings & 5 selectable Rev Limiter settings) Ignition Coil

This 4-valve, 62mm bore x 62 mm stroke engine is the newest edition directly from Daytona Motor Co. The new FDX-190 comes stock with an updated 4-speed close-ratio transmission, an AUTO-DECOMPRESSION CAMSHAFT, and reinforced crankcases.
The FDX motor is manufactured and assembled as a 190 at the Daytona factory.

• Daytona FDX 190 Engine
• Intake Manifold
• Wire Harness
• CDI: (4 selectable timing settings & 5 selectable Rev Limiter settings)
  
• Ignition Coil
• Intake manifold carb boot

*Daytona crate engines do not come with any warranty*

Users manual is available here

Starting pit bike engines will take some practice. All pit bike engines have relatively high compression ratios and require a "quality over quantity " approach to ensure quick start-ups and avoid mechanical mishaps. It is important to follow this routine the first few times you attempt to start your bike.

Warranty

Crate Engines are sold AS IS with no warranty whatsoever.

Slowly kick engine over until the kick start reaches a compression stroke (the point in which the kick start lever is hardest to push down.)
Slowly continue to press the kick starter until the engine rotates slightly through the firmest point in the compression stroke.
Allow the kick start lever to return back its top rest position
With a quick and balanced motion - Move down forcefully on the kick lever. These motors need a strong, quick kick to get started.
If you fail to follow this procedure, especially with longer stroke engines or 125cc + bores you can cause serious damage to your crankcase, clutch and transmissions assemblies!

Tips to Avoid kickback

Hold onto the crossbar pad with your throttle hand while kicking the bike over to avoid twisting the throttle open by accident
Before start up - turn the idle screw on the carburetor in a turn or 2 (turn the screw back out to normal idle setting once running.)
Use a digital CDI with variable ignition timing at start-up, this will help reduce kick back and allow the bike to start much easier compared to the stock CDI unit.
If ignition timing is adjustable it should be adjusted to the minimum
Furious, repeated kicking will not get the engine started - firm, full stroke kicks are the only way to get them to start first kick, every time "Quality over Quantity"
Throttle must be completely closed when you kick the engine over or it will kick back EVERY TIME.
A small blip of the throttle maybe used when the engine is hot if required but NO more than 10 ° opening of the throttle in any case!