Pay in installments of $9.25 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Sep 3 - Sep 8
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
BAOFENG UV-5R5 VHF/UHF Dual Band Two Way Ham Radio Transceiver Walkie TalkieThe Baofeng UV 5R5 is a compact hand held transceiver providing 4 watts in the frequency range of 136 174 MHz and 400 480 MHz. It is a compact, economical HT that includes a special VHF receive band from 65 108 MHz which includes the regular FM broadcast band. Features: Dual watch and dual reception is supported. You get up to 128 memories. Other features include: selectable wide narrow, battery save function, VOX, DCS CTCSS encode, key lock and built
The Baofeng UV-5R5 is a compact hand held transceiver providing 4 watts in the frequency range of 136-174 MHz and 400-480 MHz. It is a compact, economical HT that includes a special VHF receive band from 65 - 108 MHz which includes the regular FM broadcast band.
Features:
- Dual watch and dual reception is supported.
- You get up to 128 memories.
- Other features include: selectable wide/narrow, battery save function, VOX, DCS/CTCSS encode, key lock and built in flashlight.
- Selectable frequency steps include: 2.5, 5, 6.25, 10, 12.5 and 25 kHz. RF power may be selected at 4 or 1 watts.
- This radio comes with ANT5 SMA-J flexible antenna, BL-5 Li-ion battery (7.4V 1800 mAh), belt clip, wrist strap, AC adapter (8.4V 600ma) and drop-in charging tray.
Specifications:
- Frequency Range: 136-174 / 400-519.995 MHz
- Dual-Band Display, Dual Freq. Display, Dual-Standby
- Output Power: 4 /1Watts
- 128 Channels 50 CTCSS and 104 DCS
- Built-in VOX Function
- 1750Hz Brust Tone
- FM Radio (65.0MHz-108.0MHz)
- LED Flashlight
- Large LCD Display
- Hight /Low RF Power Switchable
- 25KHz/12.5KHz Switchable
- Emergency Alert
- Low Battery Alert
- Battery Saver
- Time-out Timer
- Keypad Lock
- Monitor Channel
- Channel Step: 2.5/5/6.25/10/12.5/25KHz
- ROGER SET
Notes:
- This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. FFC ID: 2AJGM-xxxx.
- You may be tempted to use FRS, GMRS, MURS (in the USA) frequencies. Do note however that there are restrictions on these bands that make this transceiver illegal for use.
- WARNING！MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE SERVICE SIGNALS IS PROHIBIITED UNDER FCC RULES AND FEDERRAL LAW.
Includes:
- 1 x Walkie Talkie
- 1 x 1800mAh Rechargeable Battery
- 1 x Battery Charger
- 1 x Antenna
- 1 x Bracket
- 1 x 100~240V Power Adapter (2-flat-pin plug / 106cm)
- 1 x Earphone (104cm-cable)(Free)
- 1x Hand Strap
- 1x Manual
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.3 ★★★★★
Based on 11 reviews
Sort
Product Reviews
★★★★★ 4
Reasonably adequate room divider
Size: 4 Panel-88'', Color: Beige
I'm reviewing this as I assemble it.
Couple things:
1. I didn't expect as much assembly. I've ordered dividers before and they more-or-less came as one unit. Sometimes the panels needed screwing together. These require complete assembly and come largely as three rods: two make up vertical columns and snap together. Another one (called part "C") makes the horizontal columns and you have two of these per panel (one attaches to part "A" and the other part "B"). These parts are metal with a plastic shim. Using the wood screws to attach to part "C" is a real pain in the neck. There's not much holding the panel in place so it's a little tricky.
One tactic I've found while I'm assembling that works for the initial connections from parts A and B to their respective "C" rods is to hold the screw in place with a screw driver and then rotating the rod around the screw. This will do a number on your hands if you aren't wearing gloves. This obviously doesn't work when completing the connection.
Using a driller driver on this is really near impossible because there isn't anything you can use to secure it in place. You can use it on the first panel, but as it gets longer, it becomes increasingly difficult and because it isn't wood, it's really tight. I considered drilling larger pilot holes but since there are only 4x4=16 screws I need to screw in, I just decided to use my screw driver to complete it.
2. Also related to assembly. When completing the panels (attaching parts "A" and "B" to parts "C" that have the cloth cover on it), you have to be careful that when you tighten that side that it isn't loosening the other side. Because the pilot holes are so tight, you can end up rotating the rod, which rotates it in the same direction as looser on the original side. Having someone hold the "C" rod in place while you screw it in is probably the easiest approach. I didn't have a 2nd person, so I just had to keep flipping back and forth and tightening both sides as I screwed it in. Not the worlds biggest deal, but annoying nonetheless.
3. The way the instructions are written, they seem to suggest building this thing progressively; that is, you do panel 1, then 2, connect them together, then do 3 and connect it, etc. I took a different route that I suspect saved me quite a bit of trouble, and I assembled all four panels first and THEN connected everything together.
4. For the love of God make sure you check that the plastic tip is on the same side for every panel. Otherwise, you have to take one side apart again and reverse it. On the bright side, if this happens, you've essentially bored out the pilot holes to be the correct size... which is having me question if I shouldn't have just bored them out to the appropriate width in the first place.
5. Attaching all of the panels together is also an enormous pain in the ass unless you happen to have an 88" long elevated surface. Attaching the legs either requires you to elevate one side, which will invariably twist the inexplicably cheap material in the bottom connectors... or you can attach them sideways... or you can put this thing upright, having two people hold the panels in place while you use the allen wrench to tighten the bolts on the underside. None of those are particularly great options.
NOW on to the utility itself.
1. The panels do let some light through (I didn't believe their advertising, and that was one of the reasons that I bought beige, is that I wanted it to not be too dark). They aren't transparent though, so it isn't that far off from their description. They functionally work great, and keep the mess of wires hidden and when I'm sitting at my desk, actually reflect quite a bit of light into my office. Great!
2. My wife has described these as "the most hideous piece of furniture ever conceived of by man." So it does not have spouse approval factor. Granted, she will seldom be in my office area, so that isn't the end of the world.
3. These are really hard to align in a way that doesn't look a little tacky. There are some plastic connectors but they don't do a bang up job of keeping these in place. Each panel is slightly tilted and it's... quite obvious. I may at some point make my own improvements to these to help make them more level. It's not a particularly expensive product so I wasn't expecting much so it's fine and I'm not going to ding them on the rating because of it.
All said, would I buy this product again? Probably not. It's assembly was ~90 minutes which is about 75 minutes longer than I was anticipating spending on this (not including the 5 minute writeup that I'm doing here). But am I going to return it? Also no, if for no other reason I'd be just as annoyed taking it apart and putting it in the original box to return it.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on October 31, 2023
★★★★★ 5
True to Description
Color: Black, Size: 4 Panel
Love it!! I bought it for privacy while the nurse is dressing my dad. There were several colors black matched the decor . It blocked the sunlight and street lights. Durability and quality very good. Easy closure when not in use. Lightweight. No assembly needed
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 29, 2026
★★★★★ 5
Nice room divider!
Color: White, Size: 8 Panel
The white panels are a nice off-white color. shipped in perfect condition. Already assembled so set up was quick. We use them to separate a photo studio from the main entry. Easily covers a 6 Ft. opening to the room. They are a woven material with wood colored sticks to support the weave. They are about 6 Ft. tall at the top of the curved section but less at the hinged sections. Light and easy to set up and take down. We are straddling two different floors so the extended legs at the bottom make this easy. Not sure how to clean them but they look great so far!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on October 21, 2025
★★★★★ 5
Instant Privacy
Color: Beige, Size: 8 Panel
Bought this to separate a ground level living area used as an office. Works well to cover visual clutter; allows a clean look when entering the front door. Comes fully assembled. Hinges are sturdy enough, as long as the panels aren’t stretched too far; have to allow some bend between them. For the price point, quality and functionality are satisfactory.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on August 22, 2025
★★★★★ 4
Great Divider, Just Needed Anchoring for Outdoor Use
Color: Grey, Size: 6 Panel
This room divider is very nice—stylish, lightweight, and easy to set up. I’m using it outdoors, which may not be its intended use, and I found that wind can knock it over pretty easily. Once I anchored it down, though, it worked just fine and looks great in the space. Indoors, I imagine it would be perfect right out of the box. Overall, a solid purchase with just one small adjustment needed for my setup.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 2, 2025
recommand products
Car Art "AreEssSix" Wagon Skateboard Deck 7-ply Canadian Hard Rock Maple
71.99
car like a 3rd gen Thunderbird ugly christmas sweater
40.88
2022 Bronco Sport Gray Ugly Christmas Sweater Sweatshirt
36.77
Car like a Geo Storm Ugly Christmas Sweater t-shirt
22.99
car like a 4 Door Impala Ugly Christmas sweater Sweatshirt 1969
36.95