Wire Feed Motor, Fits Many Century® MIG Welders

Wire Feed Motor, Fits Many Century® MIG WeldersDirect replacement wire feed motor for Century part numbers 216 079 666, 216 089 666, and 861 581 100. Replaces both the Italian made MAMCO motor and the OSLV motor. The diameter of the motor casing measures 3", and the length from the end of the casing to the center of the shaft measures 6 3 8". Fits the following Century Snap On MIG welders: YA205 (117 012), YA219 (117 022), YA217A (117 029), YA217A (117 058), MW120, and MW220. Fits the following

Direct replacement wire feed motor for Century® part numbers 216-079-666, 216-089-666, and 861-581-100. Replaces both the Italian-made MAMCO motor and the OSLV motor. The diameter of the motor casing measures 3", and the length from the end of the casing to the center of the shaft measures 6-3/8".

Fits the following Century®/Snap-On® MIG welders: YA205 (117-012), YA219 (117-022), YA217A (117-029), YA217A (117-058), MW120, and MW220.

Fits the following Century®/MAC Tools® MIG welders: WS225K (117-018), WS007K (117-019), WS120 (117-030), WS120 (117-038), and WS225K (117-042).

PLEASE NOTE: We do not accept returns on electrical parts. If your current wire feed motor does not run, the issue may be the motor or the circuit board. To test the motor, power the motor with a 12v (at least) power source such as a car battery or a battery charger. If the motor does not turn when connected to a 12v power source, then you need to replace the wire feed motor; if the motor does turn when connected to a 12v power source, then you may need to repair or replace the circuit board.