316489400 Range Oven Igniter for Frigidaire Kenmore Electrolux Crosley - Replaces 316428500 316428501 5304462661

316489400 Range Oven Igniter for Frigidaire Kenmore Electrolux Crosley - Replaces 316428500 316428501 5304462661316489400 Range Oven Igniter Replacement Key Features High temperature silicon carbide heating element designed for rapid and reliable gas ignition. Integrated ceramic mounting block for stable positioning within the burner assembly. Equipped with a standardized two pin plastic wiring connector for secure electrical termination. Engineered to reach the specific amperage required to safely open the oven gas valve. Protective metal cage design to shield

316489400 Range Oven Igniter Replacement

Key Features

• High-temperature silicon carbide heating element designed for rapid and reliable gas ignition.
• Integrated ceramic mounting block for stable positioning within the burner assembly.
• Equipped with a standardized two-pin plastic wiring connector for secure electrical termination.
• Engineered to reach the specific amperage required to safely open the oven gas valve.
• Protective metal cage design to shield the fragile heating element during handling and installation.

Replaces / Cross-Reference Part Numbers

• AP3963540
• PS1528534
• 316428500
• 316428501
• 5304462661
• 7316489400
• 1197384
• AH1528534
• EAP1528534
• PD00000633

Compatibility & Fitment

• Compatible with Frigidaire, Kenmore, Electrolux, Crosley, Tappan, and White-Westinghouse ranges.
• Fits various freestanding gas ranges, slide-in models, and built-in gas ovens.
• Designed for use in both bake (lower) and broil (upper) burner configurations where specified.

When to Replace

• Oven fails to heat or takes an unusually long time to ignite the gas burner.
• Igniter glows orange but does not get hot enough to trigger the gas valve release.
• Visible cracks, breaks, or white chemical "burn" spots on the dark gray heating element.
• The element does not glow at all when the oven is set to a bake or broil cycle.
• Multimeter testing shows no continuity across the igniter terminals.

Installation Tips

• Disconnect the appliance from the power source and shut off the gas supply before beginning.
• Remove oven racks and the bottom floor panel to access the burner assembly.
• Handle the new igniter only by the ceramic base; do not touch the gray heating element, as skin oils can cause premature failure.
• Unplug the existing wiring harness and remove the mounting screws (typically 1/4 inch hex head).
• Secure the new igniter in the exact same orientation as the original to ensure proper flame travel.
• Reconnect the wiring harness and ensure no wires are touching the burner or metal shielding before reassembling.